Where to find the Manual?

[pheonixtaylor]

I've found and read through the User-Guide but there is mention of a Manual else where and there is some important things that I'm trying to find out how to do such as adding charts into the PL21 that is just missing from the User-Guide.

[qqwertzde]

I have similar issues. I try to go through the checklist included in the user guide and I am failing already to locate the second item. Where are Aft and Forward exit signs? I am sure I will run into more items further down the list, so a link to more documentation or a cold and dark video would be most helpful.

Apart from this: very impressive airplane model

Thanks,
Peter

[N4GIX]

I have similar issues. I try to go through the checklist included in the user guide and I am failing already to locate the second item. Where are Aft and Forward exit signs?

Look on the ceiling of the cabin for the signs hanging there with the word "EXIT" on them.

[qqwertzde]

Thanks, found it However, is the test in position 2 of the checklist simulated? It appears not. Also,

- are you planning to add control locks? Would make sense since you already include chocks and pitot covers.

- Can you confirm that the Volt meters are simulated properly? They appear strangely static when I use it (e.g., it shows a reading for the generators even when they are off).

- One of you on Avsim was so kind to post a link to a video of the real cockpit. The bleed air valves in that video are labeled and appear to be the same as the "PNEU & ENVIR" switches in your model. Could it be that a label is missing there?

Thanks,
Peter

[N4GIX]

Thanks, found it However, is the test in position 2 of the checklist simulated? It appears not. Also,

- Can you confirm that the Volt meters are simulated properly? They appear strangely static when I use it (e.g., it shows a reading for the generators even when they are off).

- One of you on Avsim was so kind to post a link to a video of the real cockpit. The bleed air valves in that video are labeled and appear to be the same as the "PNEU & ENVIR" switches in your model. Could it be that a label is missing there?

There is no switch to control the EXIT signs, so no test either.

The volt meters appear "static" because the L/R generator cross-ties are closed. Open the cross-tie switch to check each generator separately.

Bleed Air controls are indeed the PNEU & ENVIR switches. The cockpit In that video is an older version so labeling is likely different, although the functions are the same.