1 ?, 1 Issue
-
JPL19
- Posts: 45
- Joined: Sat May 25, 2013 5:59 pm
- Location: New Mexico, USA
1 ?, 1 Issue
Issue - #1 - remain distance to final destination seems hosed, has happened on two different flights, even after landing still showed +3000 nm.
Question - #2 - was flying on heading mode and red AP arrow started flashing, could not clear in any way I tried. Was flying appr on manual so no big deal, but, how would you clear this? Cycled AP on, off and switched to other side to no avail, continued right to shut down.
Thanks.
Joe
Question - #2 - was flying on heading mode and red AP arrow started flashing, could not clear in any way I tried. Was flying appr on manual so no big deal, but, how would you clear this? Cycled AP on, off and switched to other side to no avail, continued right to shut down.
Thanks.
Joe
- Attachments
-
- 1.jpg (59.2 KiB) Viewed 748 times
-
- 2.jpg (46.77 KiB) Viewed 748 times
-
KenG
- Posts: 157
- Joined: Sat May 09, 2015 2:33 am
Re: 1 ?, 1 Issue
Issue #1 has been reported to the dev team.
Issue #2, notice you have an ALT CAUTION flag. This most likely means that the pilot and copilot baro setting are not the same and the AP kicked off because of that. Fix the copilot Baro setting and the AP should reengage,
-Ken
Issue #2, notice you have an ALT CAUTION flag. This most likely means that the pilot and copilot baro setting are not the same and the AP kicked off because of that. Fix the copilot Baro setting and the AP should reengage,
-Ken