CTD on loading

[michaelth]

I received your email and downloaded it. Install was without problem, but P3Dv4.5 HF1 crashed on loading with a ntdll error. Next try was with pre-loading the default F-22 flight. Now, the cockpit became visible. There was a constant glide slope warning. After some seconds, again CTD.

If you need something, just email me.
Michael

[michaelth]

After disabling the "Proline21!driver" gauge as pointed out in another thread, I can load it and start up the engines. What a joy to listen to the startup and see the props spooling up slowly. Hand flying is easy. Some observation:
- radio panel is always on, regardless of battery switched off.
- switches have no sound.
- PFD and MFD frames are greenish with big letters (AP/YD) on them.

Michael

[michaelth]

Update: it is indeed the MV_WXM.dll in the P3D modules folder. If I rename it, the Proline21 works.

Michael

[Regis9]

I can confirm the same issue and the same fix working on my system, FYI.

[monica6211]

I can confirm the same issue and the same fix working on my system, FYI.

Same here!

[ega]

Odd...I don´t have the MV_WXM.dll in P3D modules folder....

ega

[ega]

...certainly because I don´t have the Milviz radar...but with this latest build I can not use Proline gauges...are always black...

ega

[Raptor]

ega, post a picture please.

Also, are you using nVidia Inspector?

[JonathanBleeker]

There is a locked WX for the KA, although I am not sure if it gets installed.

[FSPrivatePilot]

Jonathan- I don't think the locked WX gets installed. I searched for it after I got a CTD trying to enable either the terrain or weather radar function....

[Regis9]

I also have the full/unlocked Milviz/Rex Wx Radar installed if that helps figure out the issue at all.

[michaelth]

The latest build 0.0.34 still has no WX DLL of its own. Therefore, this same CTD is still there.

Michael