KA350i Version 1.0.0

[Heronjr]

Now, with the GPU system working full, we can enter the data needed to fill the FMS before starting engines. But, following the Normal Procedures for start the engines WITH EXTERNAL POWER, I see that the Avionics should be OFF.

I did not try, but if the Avionics Switch is turned OFF, will the FMS still keep the data entered before?

[johnh]

Well, finally got the throttles to work! Rossco, you may want to try this. I had to set them up in FSUIPC (used Profile Specific) and set them to Send direct to FSUIPC Calibration. I then set them up in Spad.NEXT using Standard Axis and they finally worked!

I haven't fiddled around to set up Ground Fine setting but might try that later.

[Rossco]

Well, finally got the throttles to work! Rossco, you may want to try this. I had to set them up in FSUIPC (used Profile Specific) and set them to Send direct to FSUIPC Calibration. I then set them up in Spad.NEXT using Standard Axis and they finally worked!

I haven't fiddled around to set up Ground Fine setting but might try that later.

Thanks Harry,

Not got much time for simming ATM with Xmas imminent.

Hopefully get a chance to look at it in the next couple of days however I believe Milviz have a solution coming at the end of the week.

[N4GIX]

I did not try, but if the Avionics Switch is turned OFF, will the FMS still keep the data entered before?

The FMS will continue to hold entered data for 11 minutes, which is ample time to get the right engine started and supplying electrical power.

[Heronjr]

I did not try, but if the Avionics Switch is turned OFF, will the FMS still keep the data entered before?

The FMS will continue to hold entered data for 11 minutes, which is ample time to get the right engine started and supplying electrical power.

Great, thanks. This helps a lot. Happy holidays.