DXGI error on clicking battery switch cover/GPU use

[kevin_firth]

Considering I have had zero reports of DXGI errors from AMD GPU users. I've been thinking there is some issue between V5/DX12/Nvidia drivers or hardware...

Still getting DXGI errors this morning, with both sets of panel files - so wierd :S
I can't pin down any common factor.

[kevin_firth]

So, I replaced the panel files again with the non legacy backups, rebooted, and she flew perfectly for about 30mins, before generating a DXGI error.
The only constant I can identify here is that resetting the panel files (either set) allows startup and flight.

Also, worth noting Ive just seen this: https://www.avsim.com/forums/topic/5893 ... 00-as-crj/
Referencing DXGI errors with the Majestic Q400 and Aerosoft CRJ as well, so it doews appear its not restricted to Milviz.

[Slayer]

You can cause the same crash by having cranked settings or exceeding your VRAM pretty easily.

A number of people using 6gig cards get the crash instantly because their settings are too high. In fact an 8g card is minimum to run this in V5.

All I'm trying to address here on our end is the ones that have adequate systems/settings that still crash when using our product.

[kevin_firth]

You can cause the same crash by having cranked settings or exceeding your VRAM pretty easily.

A number of people using 6gig cards get the crash instantly because their settings are too high. In fact an 8g card is minimum to run this in V5.

All I'm trying to address here on our end is the ones that have adequate systems/settings that still crash when using our product.

OK, I don't seem to have any settings problems, or vRAM issues. I seem to be able to mostly avoid the DXGI errors by recopying the original panel files back before each flight.

I'll leave you with this.. https://youtu.be/_qrR41qqhJg