Pressurization Issue

[Ither]

2 flights in row and I have been getting the CABIN DIFF HI message and my pressurization is stuck at surface.

Envir Bleed Air is set to AUTO
PNEU & Envir is set to OPEN
OXY is armed
Cabin is set to 7000ft
Blowers on AUTO

It never budges--just the differential pressure moves.

I'm using the beta ASXP for P3D V5.0 (haven't moved to 5.1)

Load flight and don't change anything after that.

[Slayer]

What was your cruising altitude? DId you try to descend and see if the issue cleared?

[Ither]

23k feet and descending didn’t help until I reached point where differential pressure was gone. I could never get cabin pressurization needle to climb.

[Slayer]

I'm not able to duplicate this. I tried climbing and cruising to the 23k with aircraft set to 23k and no problems, adjusted cabin alt up and down and the system was responding normally. I did see this in beta one time but it was operator error on my part but for the life of me I cannot remember what I had set up wrong.

[Victory103]

Did you try moving the Envir Bleed Air to NORMAL?

[Ither]

I’ll try again tomorrow.