Rudder over sensitive in Prepar3Dv5

[TS1]

Is anyone else have a problem in K.A350 in Prepar3Dv5. The problem I'm having is that they are super sensitive, I just barley touch the Rudder and it turns right away. I'm using the Saitek Rudder pedals I've calibrated them in the sim prg have the drivers installed. Nothing works, anyone got an idea what is wrong. Thanks

Tony

[Slayer]

I have the Saitek Combat rudder peddals , never installed their driver , just the Windows 10 stock driver. Maybe try switching P3D to a different input mode (RAW or DirectX)

[TS1]

Thanks that worked I changed to Raw and changed the Null zone to 90. While I got you I cannot get the idle down below 1110 rpm, is the throttle, I'm using the Saitek throttle quad. I've played around with the sensitivity and Null and nothing works. Any ideas suggestions.

Tony

[Slayer]

A throttle axis should always have zero null zone and 100% sensitivity. Don't know if you tried that combo yet.

[TS1]

Thanks I'll give it a try.

[TS1]

I tried throttle at 100% sensitivity and 0 Null and still cannot get the idle down to 1050 rpm.

[Slayer]

There are differences modeled in the engine simulation for this so even between engines they will not be 100% accurate to the book based on wear and tear and other factors. Have you restored engine states in MVAMS prior to a new flight?