Blackbird Sims / Milviz Forum Archive

I installed a new P3Dv4 MV_F4SJ_Phantom_II_VA1.180221_JS into my J drive. The installation seemed normal. However I have two problems after load:
1/ I have no visual pilots in spot view.
2/ I get an alert during load that " can not find path specified: File F:\Addons\simobjects\airplanes\Milviz Phantom II J\panel\MV sounds\ Snd1.wav" (also for Snd2.wav through Snd30.wav). However, after a normal pause, the engine starts and I think I am hearing normal (engine) sounds.

What is the problem with seeing the pilots?

Best regards,

William Mackay (Bill)

1) Is your P3D v4 set to run as admin? As in right click, select Properties->Compatibility and check the box run this program as administrator.
2) Did you run the installer as admin?
3) Are you able to move the 3 SAS switches near the throttle base as well as the engine masters?

Sorry for double posting, Please see "No load-out manager" topic (above). I can not move the 3 switches just aft of the throttle base.

Bill