F-4/E won't get of the ground when ezca v2 in use.

[spronkj]

Anyone had this issue.

[doodlebug]

Do you have EZDOK? viewtopic.php?f=145&t=7746

[spronkj]

yes. I am using ezdok v2.5 and the Phantom will not come of the ground on take off. If I shut down ezdok then it flies normally.

[Krazycolin]

EZDoc is causing an issue. Disable it to fly the Phantom.

[Richard Portier]

Do you have EZDOK? viewtopic.php?f=145&t=7746

Please, do you know if an update is planned on your side ?

Thank you and Regards,

[Alvaro]

Do you have EZDOK? viewtopic.php?f=145&t=7746

Please, do you know if an update is planned on your side ?

Thank you and Regards,

If the problem is with the ADV F4E module, the answer, unfortunately, is no. Apparently EZDOK is writing/intercepting the same variables ADV is using for its external FDs ...and hence the collision.

Unfortunately the fix is very unlikely as it could involve a huge re-script work and EZDOK is not our software...

Álvaro

[spronkj]

I have now uninstalled ezdok from my system. I now have the problem with it in p3d v4. I find it impossible to land it. I tried it in p3d v3 and I am able to land it normally.
In P3d v4 as it gets close to the ground between 1000' and 500' it increases speed and then below 500' it sinks rapidly into the ground.
Does anyone else have a similar issue and how did you solve it? It seems to work fine in p3d v3 so maybe it is not totally my bad flying skills involved.

[Krazycolin]

This is a bug with P3D v4. However, our fix(es) for v4.1 aren't quite ready yet.

Sorry.

[spronkj]

Thanks, will wait for the fix and continue with P3d v3 then.