Module error on MVAMS
Posted: Sat Sep 02, 2017 6:20 pm
Hi,
just installed the new updated versions of the Phantom for P3D v4. First the "E" one, and after that the "J" and "S".
1) While the MVAMS configurator worked properly for the "E" version, trying to set the other two, a message appeared:
This very same issue appeared in the previous v3.4 platform.
2) Opening the MVMAS, I'm asked if I want to install an available update; downloaded, but this was an update for the older P3D version, that I, of course, didn't install Is it correct?
Thanks for any help
Fulvio
just installed the new updated versions of the Phantom for P3D v4. First the "E" one, and after that the "J" and "S".
1) While the MVAMS configurator worked properly for the "E" version, trying to set the other two, a message appeared:
This very same issue appeared in the previous v3.4 platform.
2) Opening the MVMAS, I'm asked if I want to install an available update; downloaded, but this was an update for the older P3D version, that I, of course, didn't install Is it correct?
Thanks for any help
Fulvio