F-4S&J AppCrash in P3Dv3.4 shortly after load up
-
B52-K7
- Posts: 19
- Joined: Sat Oct 22, 2016 4:44 pm
F-4S&J AppCrash in P3Dv3.4 shortly after load up
Back in early October 2016 I installed the F-4E in P3Dv3.4 & after about 10 seconds of sitting on the tarmac up came AppCrash, with the fault module being MV_F-4E_Sys.dll.
Milviz released a hotfix shortly thereafter & the F-4E flies nicely now.
Taking advantage of today's sale I purchased & installed the F-4S_J variants, (D/L & installed with AVirus off), & have had exactly the same short time on tarmac, AppCrash occurrence.
Fault modules are respectively, MV_F-4J_Sys.dll & MV_F-4S_Sys.dll
I am behind with P3Dv3.4 updates, but assume that if the F-4E is flying ok with my version of P3Dv3.4, , then the S&J should/can too??
Any help would be appreciated.
B52
Milviz released a hotfix shortly thereafter & the F-4E flies nicely now.
Taking advantage of today's sale I purchased & installed the F-4S_J variants, (D/L & installed with AVirus off), & have had exactly the same short time on tarmac, AppCrash occurrence.
Fault modules are respectively, MV_F-4J_Sys.dll & MV_F-4S_Sys.dll
I am behind with P3Dv3.4 updates, but assume that if the F-4E is flying ok with my version of P3Dv3.4, , then the S&J should/can too??
Any help would be appreciated.
B52
-
Raptor
- Posts: 411
- Joined: Wed Feb 26, 2014 3:07 am
Re: F-4S&J AppCrash in P3Dv3.4 shortly after load up
To use the phantoms in P3D3.4 you require the latest P3D3.4.22.19868 version