Milviz F-4 in P3D

[Staffelpilot]

Hello,
You do not want to have time to bring order.
Nobody can remember this, wan TacPack and when not.
Thank you very much
Best regards

Peter

[JonathanBleeker]

TACPACK for the F-4J/S is being worked on but I cannot promise when it will be ready. It is a very different setup compared to the F-4E so for now, disable TACPACK (set up your TPM to prompt you to load TACPACK) when you want to fly the F-4J/S and enable it when flying the E or other TP birds.

[Staffelpilot]

Hello,
I installed the F-4E / F-4J and F-4S as administrator in the version P3D V4 and carried out the corresponding update. Currently installed is the version 171026 at the F-4E (update from 22.11.2017) and EADV version 171114 from 22.11.2017.
After installing EADV, the engines will not start.
A start with menu Milviz F-4E - Signal External (GPU) in the add-ons does not work. This menu item is not available for me. The start of the engines via Ctrl. + E does not work either. The afterburner is always on when charging with EADV.
The warning lights also do not work.
I completely deleted the old version for the P3d V3 before installing it for the version P3D V4. A virus program is not installed. The installations were executed as administrator.
Even after several uninstall and reinstall there is no improvement.
Could you please help me.
Thank you very much.

[JonathanBleeker]

The ADV changed things a little. Once external airflow is signalled you have to click the start switch on the engine control panel to start. That said, if the menu is no longer around, you might have a missing library. Confirm you can move the 3 SAS switches aft of the throttles?

[Staffelpilot]

To avoid misunderstandings, which switch exactly? I can move all the switches, including those in the rear cockpit.

[JonathanBleeker]

There are 3 switches in the front cockpit on the autopilot panel just aft of the throttles. They are labelled PITCH SAS, ROLL SAS, and YAW SAS. Can you move them?

[Staffelpilot]

Hello
I just wanted to avoid that we talk about different things.
I can move the ENGAGE STABLE AUG (YAW, ROLL, PITCH).

[JonathanBleeker]

Ok so the module is loading. The Signal External Airflow should still be present then in the Addons Menu->Milviz F-4 Phantom II menu.

[Staffelpilot]

Hello, the add-on menu Milviz F-4E is not displayed with me.

[Staffelpilot]

Hello, without the installation of EADV I can start the engines, but without the Addons entry, which does not exist then. The start then takes place via Ctrl. + E.

[JonathanBleeker]

Please send a screenshot of your flightsim menu.

[Staffelpilot]

Hello, I hope you can read it.
Thank you very much

[Staffelpilot]

Hello, here I send you an outside view (without started engines).

[Staffelpilot]

Hello, here I send you a view of the warning lights.
The test switch is switched on.

[JonathanBleeker]

Can you turn on the gunsight?