Page 1 of 1
F-4E CTD P3D 4.5 HF3 [answered - installation order]
Posted: Mon Jun 29, 2020 9:36 pm
by FERG
Hi
I have recently tried to re-install the F-4E following an update to P3D v4.5 HF3.
It appears to load ok but as soon as I am in the cockpit in the sim the screen freezes then I get a CTD.
Any suggestions please
Ferg
Re: F-4E CTD P3D 4.5 HF3
Posted: Tue Jun 30, 2020 1:42 am
by Slayer
Please try running the installer again and pick to uninstall it, then please verify it's folder is gone from P3D dir/simobjects/aircraft.
May also want to check that it's module was removed from MVAMS: yourusername\AppData\Local\MVAMS\Modules
then try a clean install with latest installer.
Re: F-4E CTD P3D 4.5 HF3
Posted: Tue Jun 30, 2020 2:04 pm
by FERG
Have tried the uninstall and re-install as suggested .
When the aircraft is loaded in the sim I get a green tape across the top of the screen saying ' changed teams'..
when I try to start the engines from cold & dark the engine starts to spool up then dies and then I get a CTD.
any help appreciated
Re: F-4E CTD P3D 4.5 HF3
Posted: Wed Jul 01, 2020 9:42 am
by JonathanBleeker
Did you install in the following sequence?
Base package->TACPACK (if you have it)->ADV
Re: F-4E CTD P3D 4.5 HF3
Posted: Thu Jul 02, 2020 10:52 pm
by FERG
Hi Jonathan
I didn't realise I needed to install the ADV file as well so have now done that and in the sequence you suggested and all seems ok thanks.
One question - the engine starter switch works but it doesn't have the same degree of movement (left & right) as I remember previously?
Also can you please remind me what I need t do in the aft cockpit to get the airspeed counter to work in the front cockpit.
Thanks again
Richard
Re: F-4E CTD P3D 4.5 HF3 [answered - installation order]
Posted: Sun Jul 05, 2020 10:23 am
by JonathanBleeker
Turn on the nav computer and INS I think
Re: F-4E CTD P3D 4.5 HF3 [answered - installation order]
Posted: Mon Jul 06, 2020 10:17 am
by FERG
thank you