Flt1 GTN650 Panel textures Problem
-
- Posts: 19
- Joined: Fri Jun 07, 2019 4:35 pm
- Location: Dunedin, New Zealand
Flt1 GTN650 Panel textures Problem
Thank you for the update. I have un-installed the older version and installed V111. In the MVAMS radios option I have installed the Flt1 GTN650. The 650 appears in the top centre of the panel but there seems to be another 650 merged with the auto pilot. Refer to the attachments. If I click of the black spot on the corner just before the auto pilot on/off button, the enlarged 650 appears.
-
- Posts: 442
- Joined: Mon Dec 20, 2010 4:30 pm
Re: Flt1 GTN650 Panel textures Problem
I will investigate the cause and put the fix up shortly ,that problem exists only with that panel set combination i trust , the non WX version is correct ?
Best CJ
Best CJ
-
- Posts: 442
- Joined: Mon Dec 20, 2010 4:30 pm
Re: Flt1 GTN650 Panel textures Problem
Thankfully not too hard to fix , the attached zips contents go in the MV_PC-6_base/panel/console folder .
-
- Posts: 19
- Joined: Fri Jun 07, 2019 4:35 pm
- Location: Dunedin, New Zealand
Re: Flt1 GTN650 Panel textures Problem
Thanks for your assistance. I placed the file where you indicated and was asked to overwrite, which I did. I'm afraid there's no difference. I even re-booted my computer and re-loaded the aircraft a couple of times to no avail. It's still the same as my attachments. I note your file has "GNS430" in it's title. Will this fix my problem which is with the "GTN650"?
I'm not overly concerned about this problem as I can easily use the GTN750/650 which works perfectly. I would consider this a low priority if you have other matters to attend to.
Regards
I'm not overly concerned about this problem as I can easily use the GTN750/650 which works perfectly. I would consider this a low priority if you have other matters to attend to.
Regards