Manual problem
-
- Posts: 102
- Joined: Sun Oct 29, 2017 12:26 pm
Manual problem
Hi! When I use the Milviz manual and following the step for start procedure "battery and cart ridge" the engine will not start. Steps: 1 both engine master on. 2 right generator on. 3 both throttle idle. 4 right engine start. Result, no engine start. Is engine ignition and engine start the same? I have programmed buttons for both ignition L-R and starter L-R att my Thrustmaster Hotas Warthog in MVAMS. I use the advance F-4E.
When I try to follow Milviz manual for GPU start the engine will not start. The manual says "repeat step 5 but there is no step 5. A´m I blind? I can find step 1 2 3 4 6 7 8 9 10 11 but no step 5.
When I try to follow Milviz manual for GPU start the engine will not start. The manual says "repeat step 5 but there is no step 5. A´m I blind? I can find step 1 2 3 4 6 7 8 9 10 11 but no step 5.
-
- Posts: 193
- Joined: Mon Dec 15, 2014 2:25 pm
Re: Manual problem
Please, check this topic:
http://www.milviz.com/forum/viewtopic.php?f=145&t=8200
The ADV manual FAQ#4 explains how to start the engines using GPU air. Step 5 and 6 must be repeated for Left engine. Steps 1 to 4 don't need to be repeated.
Hope this helps
http://www.milviz.com/forum/viewtopic.php?f=145&t=8200
The ADV manual FAQ#4 explains how to start the engines using GPU air. Step 5 and 6 must be repeated for Left engine. Steps 1 to 4 don't need to be repeated.
Hope this helps
-
- Posts: 3446
- Joined: Sat Mar 13, 2010 7:38 pm
Re: Manual problem
5 and 6 being 3 and 4 but for the left engine
-
- Posts: 102
- Joined: Sun Oct 29, 2017 12:26 pm
Re: Manual problem
Thank´s! I can now start my F-4 E